Difference between revisions of "Ip (command)"
Jump to navigation
Jump to search
(→Linux) |
|||
| Line 4: | Line 4: | ||
== Linux == | == Linux == | ||
* <code>[[ip route show]]</code>. See also: <code>[[netstat]] -rnv</code> | * <code>[[ip route show]]</code>. See also: <code>[[netstat]] -rnv</code> | ||
| − | * <code>ip route add</code> | + | * <code>[[ip route add]]</code> |
* <code>ip route del default</code> | * <code>ip route del default</code> | ||
* <code>[[ip link show]]</code> | * <code>[[ip link show]]</code> | ||
Revision as of 08:28, 6 December 2020
This article is a Draft. Help us to complete it.
Contents
Linux
ip route show. See also:netstat -rnvip route addip route del defaultip link showip link set dev eth0 mtu 9000(Jumbo frames)
Policy based routing / Source routing policy:
ip route add from <source>/<mask> table <name> ip route add 1.2.3.4/24 via <router> dev eth4 table <name>
ip link add wg0 type wireguard
ip link set eth0 up
Set an IP address:
ip addr add 192.168.0.xx/24 dev eth0
Default gateway:
ip route add default via 192.0.2.2 dev eth0
ip route add default via 192.0.2.2 dev eth55
Cannot find device "eth55"
Cisco IOS
Related commands
See also
ip[link, route],ifconfignetstatsslsofpingethtoolmii-toolarpingnmcli(RHEL)routenetworkctl,netplan,tc- TCP/IP, Transport protocol, UDP, SCTP, QUIC, subnet mask, Routing protocols: BGP, routing table, Policy based routing, multicast, TCP Fast Open, RDP, TTL, RTT, MPTCP, Large send offload (LSO): (TSO, GRO, GSO, TCP checksum),
ethtool, SCTP, 5-Tuple, Check TCP connectivity, TCP window size,/proc/sys/net/ipv4/tcp_rmem, ack, List of TCP ports, localhost, broadcast address
Advertising:
