Difference between revisions of "Ip (command)"
Jump to navigation
Jump to search
(→Linux) |
(→Linux) |
||
| Line 9: | Line 9: | ||
* <code>[[ip link show]]</code> or <code>[[ip link ls]]</code> | * <code>[[ip link show]]</code> or <code>[[ip link ls]]</code> | ||
| + | * <code>[[ip link]] set eth0 up</code> | ||
* <code>[[ip link set]] dev eth0 [[mtu]] 9000</code> ([[Jumbo frames]]) | * <code>[[ip link set]] dev eth0 [[mtu]] 9000</code> ([[Jumbo frames]]) | ||
* <code>[[ip link add]]</code> | * <code>[[ip link add]]</code> | ||
| Line 19: | Line 20: | ||
| − | + | ||
Revision as of 09:17, 16 February 2021
This article is a Draft. Help us to complete it.
Contents
Linux
ip route show. See also:netstat -rnvip route addip route del default
ip link showorip link lsip link set eth0 upip link set dev eth0 mtu 9000(Jumbo frames)ip link add
Policy based routing / Source routing policy:
ip route add from <source>/<mask> table <name> ip route add 1.2.3.4/24 via <router> dev eth4 table <name>
ip link add wg0 type wireguard
Set an IP address:
ip addr add 192.168.0.xx/24 dev eth0
Default gateway:
ip route add default via 192.0.2.2 dev eth0
ip route add default via 192.0.2.2 dev eth55
Cannot find device "eth55"
Cisco IOS
Related commands
See also
ip (command),ip link,ip link show,ip link add,ip route,ip link set,ip address show,public ipip[link, route],ifconfignetstatsslsofpingethtoolmii-toolarpingnmcli(RHEL)routenetworkctl,netplan,tc- TCP/IP, Transport protocol, UDP, SCTP, QUIC, subnet mask, Routing protocols: BGP, routing table, Policy based routing, multicast, TCP Fast Open, RDP, TTL, RTT, MPTCP, Large send offload (LSO): (TSO, GRO, GSO, TCP checksum),
ethtool, SCTP, 5-Tuple, Check TCP connectivity, TCP window size,/proc/sys/net/ipv4/tcp_rmem, ack, List of TCP ports, localhost, broadcast address
Advertising:
