show interface summary

sh int GigabitEthernet 2/0/2 summary

 *: interface is up
 IHQ: pkts in input hold queue     IQD: pkts dropped from input queue
 OHQ: pkts in output hold queue    OQD: pkts dropped from output queue
 RXBS: rx rate (bits/sec)          RXPS: rx rate (pkts/sec)
 TXBS: tx rate (bits/sec)          TXPS: tx rate (pkts/sec)
 TRTL: throttle count

  Interface                   IHQ       IQD       OHQ       OQD      RXBS      RXPS      TXBS      TXPS      TRTL
-----------------------------------------------------------------------------------------------------------------
* GigabitEthernet2/0/2          0         0         0         0   1645000       171     82000       111         0

Related commands

• show interface status

See also

• show interface [ status | stats | status err-disabled | summary ]
• Cisco IOS: Cisco IOS XE, Config (mode), VLANs, Cisco IOS logging, VTP, ACLs, show logging, show logging history, show interface status, debug, archive, show archive, conf t, int, ip http server, ip ssh, ip address, vty, show mac address-table, show access-list, Access-list, ip access-group, admin